Transporting vehicles with low ground clearance
Sports cars and specialty vehicles with unusually low ground clearance cannot be loaded and unloaded onto the Auto Transport in the conventional manner. However, customers willing to direct extra effort to special loading and unloading techniques, may overcome problems that would otherwise make hauling impossible.
Loading ramp angle
You can raise the vehicle clearance by laying a 2×8 board on the ground against each ramp end. If the front of your vehicle is longer, you will need a longer board.
Clearance can be increased further by using 2 boards. If 2 boards are used, the end of the ramp is placed on top of the lower board (as shown). 3 boards can be used, with the ramp end placed on top of the second board.
A shallower ramp angle can also be achieved by pulling the truck (not the trailer) onto elevated ground to raise the hitchball.
If available, raising the vehicle clearance can also be accomplished by backing the Auto Transport up to an elevated curb, inclined driveway, or similiar area that will support the end of the ramp, and allowing the towed vehicle to be loaded from the raised area.
If clearance at the front of your vehicle is not adequate to clear the 6 inch tire stops at the front of the trailer, an 18 inch length of 2X8 can be placed on the trailer deck to increase the clearance (as shown). These boards should be centered under the tires.
If the front overhang of your vehicle is longer, you may need to position a second board to the rear of the tire-strap attachment bar as shown. Do not place any board over the top of the strap attachment bar.
Loose boards placed on the Auto Transport for loading purposes are to be removed when loading is completed